Tearing Up Old Carpet

If the pliers aren t cutting it you can also use a small crow bar to pry it back.

Tearing up old carpet.

Carpet removal costs 1 to 1 50 per square foot including labor cleanup and waste disposal. Keep both hands on the knife to avoid cutting a free hand. After you ve rolled up the old carpeting and removed it from the room you ll finally get a good look at the subfloor and any surprise damage that the carpet may have been hiding. Then grab the carpet by hand and continue to pull it up along an entire wall.

To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. This equals 48 to 72 per hour because it usually takes 3 hours to remove carpet from a 12 by 12 foot room including extracting the tack strips and staples. Fold the carpet over for easy cutting and slice it into narrow strips. Pull up a few feet of carpet and fold it over.

Use pliers to grab the carpet and pull it away from the subfloor. Go to a corner of your carpeting and run a standard screwdriver between the edge of the wall and carpet. Roll or fold the strip secure with duct tape and remove it from the room. If you are trying to salvage the floor underneath make sure you do not cut grooves in the floor with the knife.

If you reveal a carpet padding beneath keep it in place for now we ll tackle that later on. Pull up and dispose of the foam padding. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. The average hourly rate is 60 per hour so expect to pay 180 in total for a contractor to remove and dispose of 12 by.

Roll up the strips and tape them for easy handling. One way to do this is to lift the carpet away from the floor as you cut. Pull back the carpeting until the entire rug can be rolled up removed from your home and placed in a dumpster. Just grab the carpet with pliers and pull.

Use a utility knife or carpet knife to slice the carpet into manageable strips and roll the strips up as you go.