Remove the carpet tacking strips which may be nailed or stapled to the hardwood floor.
Tear up old carpet.
How to tear up carpet restore hardwood flooring step 1.
Drive long wood screws into the sub floor and through to floor joists anywhere the floor squeaks.
Level the sub floor and replace any water damaged wood as needed.
Use a utility.
To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner.
Prep before pulling up carpet.
Touch up paint on baseboards and around the.
To tear up your old carpet pull the carpet free from the tack strip connected it to the wall with pliers.
Start at one corner of your room and try to pull up the carpet.
How do you remove carpet glue.
Cut carpet into haul able pieces.
How to remove old carpet 1.
Pull up a few feet of carpet and fold it over.
Remove worn carpet pad and tack strips.
Your carpet is held down with tack strips.
If it won t come up then cut a small 6 inch by 6 inch square in the corner with your utility knife.
Then grab the carpet by hand and continue to pull it up along an entire wall.
Detach carpet from tack strips.
Remember to cut the carpet into smaller pieces as you go to make it easier to move and dispose of.
Go to a corner of your carpeting and run a standard screwdriver between the edge of the wall and carpet.
Remove this small piece of carpet and then pull upon the larger section.
Roll up the strips and tape them for easy handling.
Once the carpet is free pull the carpet up by hand.
Remove all debris from home and dispose of legally.
Detach carpet from tack strip and adjacent surfaces.
Includes planning equipment and material acquisition area preparation and protection setup and cleanup.
Apply a stain blocking primer to prevent old stains from coming up through new carpet.
Pull toward you to detach it from the sharp tack strip that holds it to the floor along the wall.
Fold the carpet over for easy cutting and slice it into narrow strips.
Just grab the carpet with pliers and pull.
Cut carpet into easy to handle.
When the corner of the carpet is loose use your gloved hands to pull along the length of the wall.
Tack strips are metal nails that line the perimeter of your walls to hold the carpet.